Self-lubricating bearings Installation Considerations

1. Make sure the sleeve before assembly, the housing bore surface without foreign body, the seat should be as smooth bore surface to avoid scratching during assembly.
2. The assembly can be surface coated with oil in the bush outside adequate help bush more easily installed, but not too much in order to avoid overloading or reciprocating motion when the sleeve will be spun off.
3. The assembly should adopt the mandrel slowly pushed (recommended hydraulic machine), which prohibits direct knock sleeve to avoid distortion.
4. To adopt the design of the housing bore easily deformable material or housing bore wall thickness is thin, please describe, so as not to deform when pressure mounted housing bore.
5. In order to make the assembly easier and does not destroy the wear layer, the transverse axis must be chamfered smooth over, shaft is made suggestions for bearing steel surface hardening treatment HRC45, surface roughness Rz2-3, surface can be plated chromium.
6. assembly possible, please greased in order to shorten the shaft surface of the sleeve to go together.